Pete Cornish

Gery Series Pedals

Pete Cornish HD SPEAKER CABLE 使用 Neutric 1/4 inch 接头，每条线缆均经过实验室严格测试。

这些线缆是专门连接您的放大器和扬声器接口并传输信号，没有任何损失及音染。

所有线缆使用超纯无氧铜，每个导体由84股0.15毫米的线芯组成，总面积为1.5平方毫米。

绝缘体是一种特殊设计的聚氯乙烯聚合物，经过多年的专业使用，最大限度地提高了绝缘体的柔韧性、耐热性和抗逆性，保证了绝缘体的长寿命。

线缆外层由一种重新白牛的特殊PVC复合材料制成，具有良好的耐磨性，这种材料几乎具有橡胶般的品质，通过高压包裹在绝缘体上。线缆在低温状态下一样可以保持良好的缠绕性。

每条线缆均需通过如下测试：

1）电阻测试，Tip to Tip，必须小于0.2欧姆，在实际使用中小于0.1欧姆。

2）电阻测试，Sleeve to Sleeve，必须小于0.2欧姆，在实际使用中小于0.1欧姆。

3）在施加电压为500VDC时进行测量，导体之间的绝缘电阻必须超过200 MegOhms。

特别提示：我们提供各种长度的线缆，在线缆超过3M后衰减将会更低，特别是在接近15米时。

Heavy Duty Speaker Cables

Following on from the universal approval of our HD Guitar/Bass Cables we are proud to introduce our Heavy Duty Speaker cables. Using Neutric 1/4 inch jacks, all personally signed and sleeved by Pete Cornish after successfully completing our rigorous tests, these cables are specially designed to be the perfect interface between your Amp and Loudspeaker Cabinet, and to transfer the signal without losses or tonal change.

The cable used is Ultra Pure Oxygen Free Copper of very generous dimensions: each conductor comprises 84 strands of 0.15mm cores with a total area of is 1.5 Sq.mm. The insulator is a specially designed PVC Polymer which maximizes the flexibility, heat and stress resistance to ensure long life after many years of professional use.

The Cable Jacket is constructed from a neoprene-heavy, special PVC Composite which has an almost rubber-like quality and is high pressure extruded over the insulated and twisted conductors. The "coil-ability" of these cables is excellent even at low temperatures.

We over-sleeve the cable with a woven gray Polyamide Braid that has excellent abrasion resistance and allows immediate identification of  the HD SPK Cables.

The tests carried out on every cable consist of :

1) Conductor resistance, Tip to Tip, must be less than 0.2 Ohms and we regularly achieve less that 0.1 Ohm in practice.

2) Conductor resistance, Sleeve to Sleeve, must be less than 0.2 Ohms and we regularly achieve less that 0.1 Ohm in practice.

3) Insulation resistance between conductors is measured at an applied voltage of 500VDC and must exceed 200 MegOhms.

We can supply HD SPK Cables of any length but would recommend that for lengths over 3m (10ft) that our EXTRA HEAVY DUTY SPK Cables would provide even lower losses particularly for lengths approaching 15m (50ft)